Symmons S-66-2-LAM-TRM-RP Bedienerhandbuch PDF herunterladen (Seite 3)

AFTER “IMPORTANT” IN BOLD TYPE ON

PAGE ONE. Reattach dome cover back

onto packing nut.

6. ALLOW VALVE TO RUN IN WARM POSI-

TION FOR A FEW MINUTES TO TOTALLY

FLUSH SYSTEM. IF SYSTEM IS QUITE

DIRTY, REMOVE VALVE SPINDLE OR STOP

SPINDLES (IF SO EQUIPPED) TO INSURE

PROPER FLUSHING. See service instruc-

tions.

7. Assemble diverter (T-139) and escutch-

eon (T-131) by installing diverter into “U”

notch located on escutcheon. Diverter

will be retained in “U” notch by integral

tabs (Models A and B only).

8. Install escutcheon on valve making sure

diverter/volume shaft (A) aligns with

mating key slot in top of diverter/volume

spindle (B) (Models A and B only).

A. B.

Push assembled escutcheon against wall

and secure to valve with two escutcheon

screws (T3-28). Snap Dial (T-130A, T-130B,

or T-132) into escutcheon slots provided.

Mount temperature control handle on

valve spindle spline as shown in ﬁgure 9.

Install shower arm, ﬂange and shower

head. See Figures 2 and 3.

9. Do not install positive shut-off devices

on the outlet of this valve or devices that

do not allow the valve to ﬂow at least 1

GPM at 50 psi inlet pressure. EXCEPTION:

If a self-closing or slow-closing valve is

installed on the outlet, the supplies of the

valve must be equipped with checks to

eliminate hot to cold by-pass in the event

the valve’s handle is not turned to off after

use. Contact your factory representative

or Symmons directly for information on

available checks.

FIBERGLASS WALL INSTALLATION

When installing Allura

®

in ﬁberglass or

panel walls and it is desired to sandwich

wall between valve body and escutch-

eon, cut hole in wall as shown in Figure

5 and mount valve with

T-177 wall mounting ﬂange from rear.

Note: It is always recommended

to secure valve piping to rough

construction and not depend on

ﬁberglass wall for valve mounting

security. On panel walls over 1” thick,

install in conventional manner.

4 3/4"

120mm

approx.

24"

610mm

6 1/4''

158mm

FIGURE 3

Model B: Shower System

THICK WALL

HOLE SIZE

1

16

''

to

3

4

''

2mm 19mm

T-177 Wall Mounting Flange

For 21mm to 1" 25mm

thick wall order part no. T-193

13

16

''

4" (101mm) Max

3" (75mm) Min

FIGURE 5

Install plug here for

shower only installation

Install plug here for

tub only installation

Copper sweat plug

1/2"-14 NPT plug

(pipe sealer required)

or

FIGURE 3A

1 2 3 4 5 6 7 8 ... 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare